- Aluminum multi-function ladder
- Kitchen stepping stool
- claw hammer
- nail puller
- pry bar
- Ratchet-handled screwdriver with multiple heads
- Socket ratchet
- Tool belt (to hold nails, screws, small tools, etc.)
- Power circular saw
- Level
- Plane
- L-square to draw straight lines for cutting
- Hand saw (used for small cuts, and for angle cuts
- Rubber mallet for pounding joists down into the joist hangers
Deck Update #4
By CosmicConservativeI am continually amazed how much work it is to fix this deck! This is my fifth or sixth day working on it (I lost count, but didn't do much over the weekend because of graduation festivities). I took some time off work to try to get this done, but it ain't gettin' done.
Today I hung and leveled the joists for the main eastern section. I have two boards that are warped (actually I had three warped boards, but one was so bad I removed and replaced it). Instead of replacing these warped ones, I'm just going to plane them down where they are warping up and getting out of level.
Overall I was pleasantly surprised how generally level it turned out. It isn't perfect by any means, but with the two boards planed down a bit, it ought to turn out okay.
I still have some components of the deck to complete, especially in one corner that was cut at 45 degrees for some reason. I have to cut a couple of boards with 22.5 degree angles on them, and to do that I have a child's protractor and a handsaw. Should be a lot of fun.
So far I have reframed pretty much the whole deck, attached about 64joist hangers, hung about 32 joists (and more than one was hung more than once) and torn down the old stairs.
I still need to rebuild the stairs, complete the 45 degree corner, do a few board replacements here and there and then reattach the balisters and railing. At the rate I'm going, I should be done by December.
Here is a complete list of my tools, in case anyone is interested:
Comments (0)
No comments on this post.